Out Front Bike Mount V2: Installation Tips
By Peak Design | Published: 2026-10-23
Category: How-to Guides
Learn how to install the Out Front Bike Mount V2 on your handlebars. Step-by-step guide with common mistakes to avoid for a secure phone mount.
Quick Answer
The Out Front Bike Mount V2 installs in minutes using a hex key and the included rubber shim, but getting the right fit and orientation takes attention to detail.
Why Mount Orientation Matters
The Out Front Bike Mount V2 is designed to sit in front of your stem, extending your phone forward for better visibility. On a motorcycle, this position keeps your phone above the tank bag and within your line of sight without blocking the dashboard. On a bicycle, it clears the stem and headset for a clean look.
The mount works with handlebar diameters from 22.2 mm to 35 mm, covering most standard bicycle and motorcycle bars. For oversized or oddly shaped bars, the included rubber shim helps fill gaps. If your handlebar tapers near the stem, test the fit in a straight section first.
Installation Steps
- Prepare the Mount and Tools: Remove the Out Front Bike Mount V2 from the box. You'll need a 3 mm hex key (included) and optionally the rubber shim. Inspect the mount for any damage. Common mistake: using a worn or wrong-size hex key can strip the screw.
- Position the Mount on the Handlebar: Loosen the clamp screw with the hex key. Slide the mount over your handlebar at the desired location—typically in front of the stem. Ensure the phone cradle faces upward and the arm points away from the bike. Checkpoint: the mount should sit level, not tilted. If the bar tapers, shift it to a straight section.
- Tighten the Clamp Screw: Hand-tighten the screw until the clamp is snug, then use the hex key to apply final torque. Do not overtighten—Peak Design recommends firm but not excessive force. The mount should not rotate on the bar when you twist it by hand. Common mistake: overtightening can crack the plastic clamp. Stop when the mount is secure.
- Attach Your Phone Case or SlimLink Accessory: If you're using a Peak Design phone case or the Universal Adapter, ensure the SlimLink magnet aligns with the mount's locking mechanism. Press the phone onto the mount until you hear a click. Test the lock by pulling gently. Checkpoint: the phone should not slide off when shaken lightly. If it does, recheck the mount's tightness.
- Test the Setup Before Riding: With the phone mounted, turn the handlebars lock-to-lock. Ensure the phone doesn't hit the tank, cables, or fairing. On a motorcycle, also check that the mount doesn't block the ignition or instrument panel. Common mistake: skipping this test can lead to phone damage or interference while riding.
Product Facts
- Out Front Bike Mount V2: Newly updated to work with even more handlebar sizes, the streamlined Out Front Bike Mount lets you rigidly attach your phone to your bike’s handlebars. This means the V2 version fits a wider range of handlebar diameters, so you're less likely to need an adapter for your motorcycle or bicycle.
Out Front Bike Mount V2
